Last Step: Wire Tees
This Tee will
be made in
the following
steps.
be made in
the following
steps.
Start with a piece of wire that is
slightly thinner than coat hanger
wire. You need a good size wire
for this to work correctly.
slightly thinner than coat hanger
wire. You need a good size wire
for this to work correctly.
Bend a little 1/8" "L" in the end of the wire.
Bend it further in to a
hook shape.
hook shape.
Crimp the fold down flat as shown. Make sure
everything is crimped flat in both directions.
everything is crimped flat in both directions.
Bend wire over pliers until
you have this 45 degree
angle.
you have this 45 degree
angle.
Now grasp the wire
as shown and bend
it back over the
pliers...
as shown and bend
it back over the
pliers...
Slide a pair of pliers up to
the end of the bent wire.
the end of the bent wire.
Crimp this bend down flat.
Hold the Tee as
shown. Turn it
over and press it
down from side to
side on a hard flat
surface. This will
square it up.
shown. Turn it
over and press it
down from side to
side on a hard flat
surface. This will
square it up.
Until it looks like this.
Again, This is what
the finished tee looks
like. Make a second
one, because you will
need 2.
Now go to the last
page and finish this
repair.
the finished tee looks
like. Make a second
one, because you will
need 2.
Now go to the last
page and finish this
repair.